Behavior and analysis of the inductor

  • 1.3K Views
  • Last Post 14 February 2023
Jagau posted this 07 January 2023

The behavior of an inductor in an electronic circuit has very interesting phenomena to observe. The purpose of this thread is to study some of them using a simple circuit.

Jagau

Order By: Standard | Newest | Votes
Jagau posted this 07 January 2023

The behavior of an inductor in an electronic circuit has very interesting phenomena to observe. The purpose of this thread is to study some of them using a simple circuit.

Jagau

Jagau posted this 08 January 2023

Practical experiment

Schematic of the experiment

A voltage of 5 VDC is applied to a 560uh inductor. Let's say the square pulse on the gate of the IGBT closes and opens at a rate or frequency of 1000 cycles per second (1ms) and the time the switch stays on is 1/10 of a second (0.5ms of DTC) .
  The behavior of an inductor acts like a passive element in an electronic circuit, IT DOES NOT CONSUME ENERGY, but we can calculate at any time what is its energy in joules that it stores in the form of a magnetic field.
 
For our practical example, the moment we turn on the IGBT (orange trace), the inductor current begins to flow (in green).

How our inductance behaves?

Jagau

Jagau posted this 09 January 2023

No energy is stored in the inductor with a pulsed DC voltage. The inductor absorbs the energy from the source and restores it entirely at the end of the pulse passing through the diode to the capacitor.
 If you calculate the product of instantaneous current and voltage, the instantaneous power is positive on the positive pulse and the bemf negative pulse is returned to be stored in the capacitor, and the net result is zero stored energy in the inductance.

However the current gradually rises as an inductor integrates its voltage over time.

what is interesting here is that due to the behavior of the inductance and the vacuum energy that surrounds it, an incredible voltage appears at the opening of the IGBT of about 600 volts with a current of nearly one ampere, we have to ask ourselves some questions, we have however pulsed this inductance only from 5 volts to a few ma.


Where does all this energy come from?

Jagau

 

Jagau posted this 10 January 2023

 

One could perhaps answer in part by these researchers said and found:

 

Nicolas Tesla

What is considered empty space is only a manifestation of matter that is not awakened. There is no empty space on this planet, nor in the universe. The ether exists and its particles are what keep the universe in harmony and life in eternity.

 

Tom Bearden  

 There is enough energy inside the space in this empty cup to boil all the oceans of the world.  This is a fact well knows to the scientific community, and was, for example, a favorite quote of Nobel Prize winning physicist Richard Feynman.

 

Dr Tom Valone

One can put forth the hypothesis that ZPE is potentially such an energy source that can possibly explain the "excess output" inventors have claimed to observe. The calculated spatial density of ZPE is incomprehensibly large. If these calculated values are correct and a very small fraction of ZPE could be obtained in a system output, then this output could readily exceed the conventional types of energy entering the system. 

 

With the discovery of ZPE, scientists find that space is rich with activity from virtual particles and full of energy. Therefore, physicists like to call it the "physical vacuum" when they want to talk about ZPE. Furthermore, the vacuum also vibrates and "fluctuates." In fact, that is the essence of ZPE. Vacuum fluctuations are even predicted by a branch of physics, started by Albert Einstein, Neils Bohr, and Werner Heisenberg, called quantum mechanics.

 

 

Moray King

 

Moray King, who has been studying and lecturing on ZPE for more than 30 years and has published two books on this topic, there are a few basic principles that do allow ZPE to be tapped, and these principles have been incorporated in technology that inventors have claimed achieved this result. 

The standard scientific belief is that the second law of thermodynamics must cause systems to become more random and disordered; however, nonlinear systems are not restricted to this "law."

 

Dr Ronald Stiffler

 

The energy grid is the underlying structure or foundation that powers the universe. It is called a network because it is made up of an almost infinite number of energy nodes, which are linked or joined to each adjacent energy node by connecting conduits, which support the flow of energy through everything. the almost infinite energy network.

 

All waveforms (frequencies) in the universe ride on energy conduits between energy nodes. Each node, when opened, can offer all the energy of the universe because it is a virtual connection. You cannot increase the energy beyond this level, but what is so clear is that we only have access to one set of nodes to obtain unlimited energy. The network appears three-dimensional in such a pictorial view, but when interfaced it acts as a set of nodes, so when you connect to, say, 1500 node pairs, they all resolve to one node pair , just like mother nature.

 

Opening a knot is what we are all looking for, the amount of energy you get is how wide you open the door. Think of a door and a mass of people wanting to get through. What factors affect the number of people per period? I guess most will guess first how wide the doorway is, then we'll say how fast people can move, what is the mass of each person. All factors affect who and what comes through the door and even if the door is already open.

 

I firmly believe in what these researchers have said and affirmed here.

 

Pour yourself a good cup of hot coffee, sit down and reread what these great researchers have written, they are deep thoughts. If these great men all came to have the same way of expressing themselves, there must surely be a good deal of truth there.

Jagau

Jagau posted this 13 January 2023

We come back to our experience of 5VDC pulsed at 10.1%

We can notice the significant difference in power transmitted to the coil when the current probe is placed just at the output of the power supply,negative side.

 

 

and in the second case at the negative output of the capacitor precharged by the power supply.

The discharge of the capacitor will always be more powerful than that of the discharge of the power supply without a capacitor at the input.
The behavior of an inductance is greater di / dt when discharging a precharged capacitor at the input. Whether it is for the ZPM or the Melnichenko effect, the fact of taking it into account greatly increases the effect produced, taking it into account in your experiments is always a winner

Jagau

realco posted this 03 February 2023

Quoting:Jagau

Hiall

In taking measurements when you have inductors with a behavior with a lot of RF around, I would like to share with you a part of the unfinished work of Dr R. Stiffler who gives excellent advice in taking measurements  with an inductor while avoiding the potential for error readings caused by the powerful electric fields with a lot of RF.
I count on one day humbly continuing his work.

Here is the schematic of a way of connecting its DDM with good reading measurements.

 

AV plug is if you have one in your circuit, no need of it you do not have one in your circuit.

The ferrite beads are there to eliminate RF interference, we can adjust them to our circuit depending on the frequency on which we are working, DG key offers a range of different frequencies available.

As in the circuit above the ferrites offer a low impedance at 10 Mhz and cut the others.

I believe that he will be useful for all. The DR Stiffler RF engineer, supports researcher in the field of Spatial Energy Coherence. Incredible what he left to the community
Jagau

Hello Jagau. I personally thank you for this 'gift' that you posted! Sincerely ...realco

 

 

 

Jagau posted this 08 February 2023

The sea of energy that surrounds us, as T H Moray said, is the form of energy that is real and that the Casimir effect has proven to exist beyond doubt.
While experimenting on the behavior of inductors I noticed that a few years ago very serious research had been done in this direction. Mr. Ronald Stiffler RF Eng. had succeeded in demonstrating that the coherence effect between 3 frequencies could, from the resonance of a certain arrangement of coils, produce a resulting longitudinal wave and open a connection (node) to this sea of energy that surrounds us.
The schematic with which I will continue to experiment on the behavior of inductors is this one:

To be continued with the first results.

Jagau

Jagau posted this 13 February 2023

I built the circuit above, the most difficult is the construction of the 3 coils done by hand and checked with the LCR meter. With an input of 10.7 volts, 10 big leds of 3 volts connected in series on the avramenko plug light strongly following a precise adjustment of L1.

On a bandwidth span of 350 Mhz, this little beast is very very rich in harmonics, surprising how it being with this assembly I get 10.3 Mhz of central frequency. Very interesting experiment to do on coils behavior.

 

With a view on spectrum analyzer (TinySA), harmonics are very present all along the spectrum 

You can see on the Spectrum Analyser a multitude of harmonics produced by spatial coherence at left starting a 0 hertz passing by 10.3Mhz under digit 1 and at right stop at 350Mhz. Resolution bandwith is automatic at 621Khz but i can change to have awider one.

Simply wonderful with lots of energy available.

It seems that this little beast is capable of taking even more. The following will be the addition of an additional load of 10 other LEDs in order to verify the consumption behavior (input power) of the circuit.


Jagau

Fighter posted this 10 January 2023

Quoting:Jagau

I firmly believe in what these researchers have said and affirmed here.

I absolutely agree, we should really listen and understand what all the great researchers before us told us.

However we want to call it, zero-point/quantum/aether field, it's the source our experimental devices are getting their extra-energy from. We're not talking about perpetuum-mobile or impossible physics here, it's just about an universal energy field present anywhere in the universe which is not recognized by our "physics" for the reasons we already know: if humankind would have unlimited and free energy sources everywhere then who would pay daily to the energy cartels for electricity, gas, home heating and cooling, hot water etc. ? How would they make hundreds of billions profit every year from our money we make from our work ? That's why they suppressed the knowledge of the great Nikola Tesla, that's why they suppressed other researchers and their devices since then, that's why they truncated Maxwell's equations (see Heaviside's "work") removing this entire class of overunity devices from Maxwell's original equations but they kept telling us in school that those truncated equations are actually Maxwell's equations.

Regards,

Fighter

"If you want to find the secrets of the universe, think in terms of energy, frequency and vibration."
Nikola Tesla
Atti posted this 14 January 2023

I support it! I weighed it years ago and the difference is huge!

Atti.

Shelfordella posted this 28 January 2023

Should it not be vector sum, q1+q2, instead of cross product? The result of a cross product of 2 vectors is another vector perpendicular to the 2 vectors, but it is 0 at 0 and 180 degrees (q1 x q2 = q1q2sin(angle)). 

This may be the moment to look at quaternions they aways talk about, they have a scalar and 3 vector components, when vectors sum to zero, the scalar remains, that's what Bearden said.

Another interesting thing to look into is Clifford algebra for electromagnetics.

https://nanopdf.com/downloadFile/motional-electric-fields-associated-with-relative-moving-charge_pdf

The first type of induction is known as flux cutting is due to relatlve spatial motion with respect to magnetic flux. The electric field resulting from this type of induction is the motional electric field. This type of electric field has unique propertles that separate it from the other two. Experimentally, it ls eonfirmed that this electric field is immune to shielding due to the fact that nagnetic (not electric) boundary conditions apply to it. Motional electric flelds can also exist where the total magnetic fietd that induces it consists of non-zero conponents that sum to zero The other type of induction is due to llnking time changing magnetic flux.

"A little theory and calculation would have saved Edison 90 per cent of the labor." Nikola Tesla

Close