Hiall
This thread will be dedicated to an inventor who left us a lot of information on "Spatial Energy Coherence" commonly called "SEC"
This circuit connects to the sea of energy that surrounds us by opening a door with it. Building different circuits will teach us more and how to do it.
Thank you Dr. Ronald Stiffler.
Jagau
Hiall
This thread will be dedicated to an inventor who left us a lot of information on "Spatial Energy Coherence" commonly called "SEC"
This circuit connects to the sea of energy that surrounds us by opening a door with it. Building different circuits will teach us more and how to do it.
Thank you Dr. Ronald Stiffler.
Jagau
And now 48 LEDs and power input 11 volts 40 ma. = 0.44watts
LEDs are very bright on after reconfiguration of L1 and L2 with 24 gauge for these coils
Frequency of 10.21Mhz at -21 dbm
wonderfull circuit and a lot of enrgy around
Jagau
Yes you read Fighter correctly
However after other experiments that I will present here the optimization of the coils gives me a better performance when the 3 coils are in spatial arrangement all at 90 degrees.
The device as in my first experiences as you saw works ok but has better performance with the coils in mutual inductance cancellation at 90 degrees. The best performance was achieved with the L3 coil standing upright on the board, L2 left to right and L1 front and rear plane.
This photo of the DOC is very representative
I also reviewed the design of the L3 coil output which I believe makes all the difference. As I continue to experiment with this amazing circuit I discover and learn new things that I didn't suspect, that's experimentation.
The experiments are only at its beginning and the photos that I send are constantly evolving and I will show them here for sure.
Jagau
Hi Atti
These are very good questions you ask, according to my first try and what I observed following the recommendations of the inventor friendly called the DOC;
About your questions;
-Is it necessary to loosely couple the inductors?
The 3 coils must, for better performance, be at 90 degrees relative to each other in a 3 dimmension plane, thereby canceling the mutual inductance between each of the coils
-What happens if the connection is tight?
The connections between the components must be as short as possible given our extended frequency up to 500 Mhz
-Can the resonance points come from an external factor? For example, is the "primary" vibration circuit separate and the "secondary" vibration circuit separate?
L1-c1 establishes the frequency of use and I admit that my experiments at this stage are primitive but given that what I understand for the moment the coherence (Wiki makes a good definition of it) and the fact that this circuit operates in very high impedance any nearby object or mass, even our hand, disturbs its behavior.
https://en.wikipedia.org/wiki/Coherence_(physics)
The coherence resonance is established between L2-L3 and the internal capacitance of the circuit, in addition to the Self resonance of the coils and when the BJT enters the negative region, a pumping effect of the energy of the environment occurs. Negative region is between Vpeak and Vvalley
But as you can see, this type of experience is the one I've been looking for for a long time because I firmly believe that the energy around us is available.
I hope that answers your questions if there is anything else let me know.
Jagau
Hi all
The tests are progressing, I have finished building my two measurement filters according to the recommendations of the DOC,
In the continuity of finding the spatial resonance the coils built in gauge 24 are very useful. When we collect the mass on the side of the coil with the SA inserted without contact in the coil, we obtain exactly what the DOC said in its YTs.
And with a little work, even amplified signal, no batteries just earth ground effect with slip probe inside the coil.
The various experiences follow one another and more and more satisfied
Jagau
When an Exciter circuit with SEC technology is properly adjusted with all 18 LEDs at full brightness with 9 volts 25ma, viewed with a standard span of 33mhz and (1) 14.2 Mhz at maximum
and watched this little beauty with a span of 350 Mhz
Incredible to see so much energy available through coherence,
I have never seen anything so incredible 350 Mhz of rich harmonics .
All credit goes to the late Dr Ronald Stiffler, thank you
Jagau
Hi Jagau.
had succeeded in demonstrating that the coherence effect between 3 frequencies could, from the resonance of a certain arrangement of coils, produce a resulting longitudinal wave and open a connection (node) to this sea of energy that surrounds us.
I consider this statement important.
"Resonance between 3 frequencies"
Question.
-Is it necessary to loosely couple the inductances?
-What happens if the connection is tight?
-Can the resonance points come from an external factor? For example, is the " primary" vibration circuit separate and the "secondary" vibration circuit separate?
In the future, I will read the works with interest.
Atti.
You could try and see what happens if you remove the LEDs and place a coupled inductor or transformer in its place, and connect a load on the output coil. This way you can see whether displacement current can cause magnetic induction inside a coil. That would be interesting.
I remember the lecture by Walter Lewin in which he showed how a magnetic field surrounds the path in the discontinuity of a capacitor.
"A little theory and calculation would have saved Edison 90 per cent of the labor." Nikola Tesla
Regarding the geometry of an av plug Alexander Frolov had noticed that the length of cable connecting that to the source circuit was very important.
The generator of changing potential is connected to the wire. Length of the wire must be corresponding to some resonance value. In resonance case potential changes in the point O are maximum. N.Tesla used special coil to find the resonance state in his single-wire power transmission system.
An interesting little document on AV plug
It should not however be forgotten that according to the DOC;
There are three parts to a SEC Exciter, TEM (conventional), Longitudinal, (conventional) and Spatial (unconventional). SEC is Spatial in that it can stimulate the 'Energy Lattice' (the foundation of everything and cause an increased localized activity which results in energy being cohered into the exciter. The secret to SEC is to funnel this cohered energy into a localized load on the exciter.
Jagau
I definitely like the term Chronal Field used in that document. It coorelates perfectly with what W.B. Smith refers to as the Tempic Field. I have always suspected this was the hidden, pervasive field most of us overlook. When we think in terms of an object having potential memory, it tends to make the brain hurt. The concept would seem to not only be a sound one, but should be obvious since potential cannot change instantly, anymore than mass can change instantly.
Not entirely certainly the below method is applicable, but it may be relevant as an alternate method for energy capture.
If instead of capacitive plates, imagine using capacitive spheres. Seems this would certainly be spacial in its implementation.
SEC stands for 'Spatial Energy Coherence' and is a theory developed by the DOC, on how 'Exciters' are able to 'Cohere Energy' from as the 'Spatial Energy Lattice'.
When one is able to "cohere" grid energy and under proper circuit design, one can see a "coherent energy coefficient" CEC > 1.
SEC is not the circuit, the exciters are the circuits. Exciters do not produce beat frequencies below 4 MHz under all conditions.
The terminology used by the DOC is very explicited, CEC is for coherence coefficient and Pout / pin = CEC greater than 1 when the exciter is properly adjusted.
Jagau
No one online at the moment
